+32 (0)2 895 67 90 info@in2cloud.be

Door Phone Grandstream

Door Phone Grandstream

Grandstream GDS3705 and GDS3710 Door Phones are configured partly on the In2Cloud Portal and partly via the device GUI. 

1. Provisioning through the In2Cloud portal

Add a device of type Door Phone

Fill in the Device Nickname, Mac Address and select the model and type. Once the device is created connect your Door Phone to the Internet. In the example we chose a GDS3710 .

When the provisioning is done you should be able to see the Door Phone between the registered devices on the server. 

Configure the action of the doorbell button on the Door Phone via the extra tab of the device.

Without Video Preview:

Fill in the callflow (extension) number of the device that will be called when pressing the button (audio or video but without video preview before answering).

With Video Preview:

Fill in the IP address and local SIP port number of the device that will be called when pressing the button (audio or video and with video preview before answering)

You can find the port number on the GUI of the phone under Account => SIP Settings => Local SIP Port

Note that it is best to use static IP addresses on your phones in order to have concistency with this type of configuration. 

Note : If you want to be able to call multiple destinations you can seperate the inputs with a comma (up to 4 simultaneous SIP calls).

Timing can also be changed to this page. It should be left to 0 info you want to do mutliple ring and changed to the desired timing if you want to ring the devices in order. 

2. Settings to be configured through the GDS3710 GUI. 

– Enable Direct IP call if you want to obtain de video preview. In this case the call will be established on the local network without going through the In2Cloud server.

– You need to chose between Serial Hunting and Parallel Hunting depending on the ring strategy that you want to be applied when the Door bell button is used. In case of Serial hunting, the timing between stations is determined via the ring timeout that you configure in the extra section of the device on the IN2CLOUD portal.

If you need to open a door with the Door Phone please ensure that you defined a Remote PIN code and that you enable the DTMF to open the door.